TOP_en

Break Hub Feather

Ribbon: Top Mechanical Draw > Mechanical Draw > Slits > Break Hub Feather

• What
• Draws the section of a hub with flap fitting.

• Why
• Avoid to draw a circumference (or two, to display the outer diameter of the hub) and apply accordingly the flap fitting. Also the symmetry axis is displayed.

• How
• Insert the shaft’s diameter (minimum 6.0; maximum 500.0), then, if requested to insert the centre of the shaft , digit Angle or A and will be inserted before the centre the positioning angle of the flap (90° by default). To draw it insert the outer diameter.

Example 63. Break Hub Feather

Command: Top_LngMozzo <ENTER> Shaft
                    diameter <6.0>: <ENTER> Flap Insertion
                    angle/<Shaft Center>: Hub’s outer diameter: Or:
                    Command: Top_LngMozzo <ENTER> Shaft diameter
                    <6.0>: <ENTER> Flap Insertion angle/<Shaft
                    Center>: Angle <ENTER> Flap Insertion Angle
                    <90>: 0 <ENTER> Shaft centre: <ENTER>
                    Hub’s outer diameter: <ENTER>