Top_LngAlbero
Break Shafts Feather
Menu: Top > Shafts > Break Shafts Feather
- What
- Draws the section of a shaft with flap fitting.
- Why
- Avoid to draw a circumference and apply accordingly the flap fitting. Also the symmetry axis is designed.
- How
- Insert the shaft’s diameter (minimum 6.0; maximum 500.0), then, if requested to insert the centre of the shaft , digit Angle or A and will be inserted before the centre the positioning angle of the flap (90° by default).
Example 62. Break Shafts Feather
Command: Top_LngAlbero <ENTER> Shaft
diameter <6.0>: <ENTER> Flap Insertion
angle/<Shaft Center>: or Command: Top_LngAlbero
<ENTER> Shaft diameter <6.0>: <ENTER>
Flap Insertion angle/<Shaft Center>: Angle
<ENTER> Flap Insertion Angle <90>: 0
<ENTER> Shaft centre: <ENTER>
Nota |
|
The references of the fitting’s dimensions are in the table UNI 6604-69. |